Drill rigs - TMB 10

The fully hydraulic TMB 10 crawler drill rig has been developed for use in many areas of the constuction industry. It is used for disaggregation in quarries, forest roat building, slope reinforcement drilling, drilling for blasting, trench drilling, etc.

The TMB 10 is a fully hydraulic crawler drill rig with a articulated boom, carriage, hydraulic hammer and dust collector. The undercarriage consists of a frame with crawler oscillation and corresponding components and bodywork. The drill is powerd by a diesel engine over hydraulic motors and whell hub drives.

Transport measurements:
Length:	330 in
Width:	93,3 in
Height:	104,5 in
Total weight:
Weight:	19425 lb
Chassis:
Tramming speed:	1,7 / 2,9 m/h
Climbing ability:	80 %
Crawler oscillation:	+/- 15 deg
Ground clearance:	10,63 in
Ground pressure:	73 kN / m2
Power pack:
Diesel engine - type:	Cummins QSB 4.5-C160
Rated capacity:	160 HP
Speed:	2200 rpm
Screw-compressor type:	GHH CF75G
Displacement:	5,7 m3/min
Operating pressure:	10 bar
Hydraulic pump type:	axiel piston pump
Hydraulic system:	load sensing system proportional control for percusssion, rotation and feed motor
Gear pump set:	26+14
Operating pressure:	250 / 200 bar
Diesel tank:	79,15 g
Hydraulic reservoir:	52,8 g
Accessories for power pack:
Return line filter, oil-air cooler, combi-cooler
Feed:
Type:	CF 140
Feed for drill steel with max. lenght:	14 ft
Feed motor - type:	TMF 25
Feed force:	25 kN
Feed advance:	49 in
Boom:
Type: TBA-articulated boom with rollover
Hydraulic drifter:
dependins on application
Dust collector:
Type:	HSL900A
number of filters:	12
Filter area:	14,4 m2
Weight:	507 lb
Control panel:
Control panel for drilling:	electric remote control
Control panel for tramming	manual actuated valves